Multiple Distribution Module Passive, Each socket can be switched in 3 variants (1,2, off), 8-Way multipin: all switches on the left or right, Two times 4-fold multipin: four on 1, four on 2, Eurorack format, Width: 6...
Dual Voltage-Controlled Amplifier Module A-132 contains two voltage-controlled amplifiers with linear characteristic, which are designed mainly to control the amplitude of the control signals, for example: ADSR amount,...
Multi-Connector (2x 4 multi-port distributors)The A-180 module is a simple, passive multiple distributor. It contains two groups, each with 4 connected sockets, so that you can "multiply" the input or output of a...'
Euro Rack Module Provides 3 adjustable DC voltages, Adjustable voltage range: 0 - 5 V or -2.5 to 2.5 V, Euro rack format, Width: 8 HP, Depth: 40 mm, Power consumption: +20 mA (+12V)/ -10 mA (-12V)
ADSR Envelope Generator The module A-140 is a envelope generator and since it delivers control voltages, belongs to the modulation-modules. As soon as the ADSR is triggered at gate-input, it generates an adjustable...
Bus Access Module (BAC) An active bus access module (BAC) to feed CV and gate into the bus via a jack plug (ex., with several A-100 racks or an external MIDI-CV / gate interface), Alternatively, the module can also be...
Low Frequency Oscillator 2 With adjustable waveform, 3 outputs, Frequency range selectable, Eurorack format, Width: 8 HP, Depth: 45 mm, Power requirement: +20 mA (+ 12V) / -20 mA (-12V)
Slew Limiter Module Voltage controlled, Applied voltage jump at the input leads to a rising or falling curve whose steepness is controlled with the rate knob, Euro rack format, Width: 8 HP, Depth: 40 mm, Power...
Power Adapter 12 V / 2000 mA, -12 V / 1200 mA, 5 V / 4000 mA, 100-230 V ATTENTION - the connection and installation of parts which carry mains voltage (mains input, power supply, connecting cable, etc.) must only be...
S-Trigger Cable With built-in S-trigger electronics, Length: 1.2 m, 3.5 mm Mono mini jack plug to 1/4" mono jack, Converts gate to switched trigger (S-trigger)'
Cable Set For DIY Synthesizer kit, Consisting of two 16-pin and five 10-pin flat-ribbon cables, With matching counterparts to the 2-pin contact strips on the DIY Synth board, Length: Each 50 cm, The other end of each...
Mini PSU / Backplane Module comes preassembled and tested, +/- 12V @ 200 mA and +5V @ 50 mA, Integrated backplane with 4 slots, Especially for applications with just one or a few modules (max. 200 mA, max. 4 modules),...